Pyle plcd29 사용자 설명서

3

• Choose the mounting location where 

the unit will not interfere with the 
normal driving function of the driver.

• Before finally installing the unit, 

connect the wiring temporarily and 
make sure it is all connected up 
properly and the unit and the system 
work properly.

• Use only the parts included with the 

unit to ensure proper installation.
The use of  unauthorized parts can 
cause malfunctions.

• Consult with your nearest dealer if 

installation requires the drilling of holes
or other modifications of the vehicle.

• Install the unit where it does not get in

the driver’s way and cannot injure the
passenger if there is a sudden stop, 
like an emergency stop.

• If installation angle exceeds 30˚ from 

horizontal, the unit might not give its 
optimum performance.

• Avoid installing the unit where it would

be subject to high temperature, such 
as from direct sunlight, or from hot air,
from the heater, or where it would be 
subject to dust, dirt or excessive 
vibration.

DIN FRONT/REAR-MOUNT
This unit can be properly installed either
from “Front” (conventional DIN Front-
mount) or “Rear” (DIN Rear-mount
installation, utilizing threaded screw holes
at the sides of the unit chassis).
For details, refer to the following
illustrated installation methods.

1. Dashboard
2. Holder

After inserting the holder into the 
dashboard, select the appropriate tab
according to the thickness of the 
dashboard material and bend them 
inwards to secure the holder in place.

3. Screw

1. Dashboard
2. Nut (5mm)
3. Spring washer
4. Screw (5 x 25mm)
5. Screw
6. Strap

Be sure to use the strap to secure the
back of the unit in place.  The strap 
can be bent by hand to the desired 
angle.

7. Plain washer

30˚

(Fig. 1)

1

3

2

182

53

(Fig. 2)

1

2

6

5

4

3

7