Pyle pltv65r 사용자 설명서

5

 

Outer Trim Ring

L Key

Sleeve

R Key

Mount the sleeve by inserting the
sleeve into the opening of the 
dashboard and bend open the tabs 
located around the sleeve with a 
screwdriver. Not all tabs will be able to 
make contact, so examine which ones 
will be most effective. Bending open
the appropriate tabs behind the 
dashboard to secure the sleeve in 
    

Reconnect the wire harness and the 
antenna and be careful not to pinch
any wires or cables. 
Slide the unit into the sleeve until it 
Locks into place.
To further secure the unit, use the 
supplied metal strap to secure the back 
of the unit in place. Use the supplied 
hardware (Hex Nut (M5mm) and Spring 
Washer) to attach one end of the strap 
to the mounting bolt on the back of 
the unit. If necessary, bend the metal 
strap to fit your vehicle's mounting area.
Then use the supplied hardware  

7.

8.

5.

6.

place.    

Tabs

Screwdriver

Sleeve

Dashboard

any wires or cables.

Mounting Bolt

Plain Washer

Tapping Screw

Metal Strap

Spring Washer Hex Nut

(Tapping Screw (5x25mm) and Plain 
Washer) to attach the other end of 
metal strap to a solid metal part of the
 vehicle under the dashboard. This 
strap also helps ensure proper electrical 
grounding of the unit.

Reconnect the cable to the vehicle     
battery's negative (-) terminal. Then 
replace the out trim ring.

9.

Make sure the ignition is turned off, 
then disconnect the cable from the 
vehicle battery's negative (-) terminal.
Remove the metal strap attached the 
back of the unit (if attached).
Lift the top of the outer trim ring then 
pull it out to remove it.
Insert both of the supplied keys into the 
slots at the middle left and right sides of 
the unit, then pull the unit out of the 
dashboard.

1.

2.

3.

4.