Viking Range ddfb304 사용자 가이드

다운로드
페이지 22
Operation
25
24
Operation
Freezer 
(all units except bottom-mount)
Wire Shelf Adjustment
You can easily adjust your freezer's
shelves. To remove a shelf, simply
tilt it up at the front, releasing the
hooks from the shelf support.
Then, pull the shelf straight out. To
replace, guide the rear hooks of
the shelf into the slots in the shelf
supports. Then, tilt the shelf up at
the front until the hooks drop into
the slots. Next, lower the front of
the shelf to a level position.
Wire Basket Adjustment 
(all freezer model only)
You can easily adjust your
freezer's wire baskets by
moving the dividers. To
remove a divider, simply grasp
it in the center, and pull the
divider straight up. To replace,
guide the divider around the
basket wires in the desired
location, then push the divider
down until it stops.
Automatic Ice Maker 
(all units except all refrigerator)
The ice maker and slide-out ice drawer on your refrigerator
are not adjustable, but the ice drawer slides forward for easy
access to ice. 
After the refrigerator reaches normal temperature, the ice
maker fills with water and begins operating. Under normal
conditions, the ice maker will produce seven to nine batches
of ice per 24 hour period.
NOTE: 
Allow 24 to 48 hours after installation before looking
for ice in your ice drawer. You should discard the first three
full drawers of ice produced by your refrigerator, and should
also throw out the first drawer full of ice your refrigerator
produces after extended periods of non-use.  
During ice production, the ice
maker arm raises and lowers.
When the ice bin is full, the ice
maker arm automatically turns
the ice maker off. To manually
stop ice production, raise the ice
maker arm. You will hear a
definite click when you have the
arm in the right position. The ice
maker won't produce any more
ice until you push the ice bin all
the way back into place.
Ice Bin Adjustment 
(all freezer model only)
Ice bins can be adjusted to match the way you use your
freezer. The ice bin on the left-hand side is used for collecting
ice from the ice maker. Once the left-hand ice bin is full, the
bins can be reversed so additional ice is made. If the ice
maker is not operating, the ice bin can be used for cold
storage.
CAUTION
To avoid damage to ice maker, observe the following:
• Do not force ice maker arm down or up past stop position.
• Do not place or store anything in ice bucket.
Off
Position
On
Position
Ice 
Maker
Arm