HP MDS600 AX670A 사용자 설명서

제품 코드

AX670A

NOTE:

NOTE: HP has not tested or validated the MDS600 with any third-party racks. Before installing the MDS600 in a third-party rack, be
sure to properly scope the limitations of the rack. Before proceeding with the installation, consider the following:

You must fully understand the static and dynamic load carrying capacity of the rack and be sure that it can accommodate the
weight of the MDS600.
You must install a 1U tray (part no 501037-B21 ) beneath the MDS600 to ensure proper support.
Be sure sufficient clearance exists for cabling, installation and removal of the enclosure, actuation of the rack doors, and full
articulation of the drive drawers

MDS600

INPUT POWER

INPUT POWER
(per power supply)

Rated Line Voltage

90 to 132 VAC 180 to 264 VAC

Rated Input Frequency

47 to 63 Hz

Rated Input Current

10A (at 100 VAC), 7.8A (at 200VAC)

Rated Input Power

964 W (at 100 VAC), 1412 W (at 240 VAC)

TEMPERATURE AND

TEMPERATURE AND
HUMIDITY RANGES

HUMIDITY RANGES

Operating Temperature

50° to 95° F (10° to 35° C)

NOTE:

NOTE: Maximum Rated 10°C per/hr (50°F/hr)

Storage Temperature

-22° to 140° F (-30° to 60° C)

NOTE:

NOTE: Maximum Rated 20°C/hr (68°F/hr)

Operating Humidity

10% to 90% relative humidity (Rh), 28º C (82.4º
F) maximum wet bulb temperature, non-
condensing

Non-Operating Humidity

Non-Operating Humidity 5% to 95% relative humidity (Rh), 38.7º C

(101.66º F) maximum wet bulb temperature,
non-condensing

PHYSICAL

Length

89.12 cm

Width

44.7 cm (17.6 in)

Height

22.1 cm (8.7 in)

Chassis

72.58 kg (160 lb) with no hard drives installed

Weight

145 kg (320 lb) with hard drives installed

Power Consumption

Power Consumption
(maximum)

(maximum)

Power consumption at 208V

Drive Type

Typical

Service Position Maximum

7200 RPM SATA

800W

1140W

10K 400G SAS

940W

1340W

15K SAS

1280W

1710W

Power consumption at 120V

Drive Type

Typical

Service Position Maximum

7200 RPM SATA

1000W

1500W

10K 400G SAS

1100W

1600W

15K SAS

1320W

1770W

NOTE:

NOTE: Input Power and Heat Dissipation specifications are maximum values and apply to worst-case
conditions at full rated power supply load. The power/heat dissipation for your installation will vary
depending on the equipment configuration.
NOTE:

NOTE:

NOTE: Temperature ratings shown are for sea level. An altitude derating of 1°C per 300 m (1.8°F per
1,000 ft) to 3048 m (10,000 ft) is applicable. No direct sunlight allowed. The upper limit may be limited
by the type and number of options installed.
NOTE:

NOTE:

NOTE: Storage maximum humidity of 95% is based on a maximum temperature of 45°C (113°F).
Altitude maximum for storage corresponds to a pressure minimum of 70 KPa.
NOTE:

NOTE:

NOTE: The "service position maximum" column is the test result with the drawers open.

QuickSpecs

HP 600 Modular Disk System

Technical Specifications

DA - 13257 North America — Version 23 — October 14, 2011

Page 18