JVC gr-d370 사용자 설명서

MasterPage: Left

The camcorder needs to be powered up to load 
or eject a cassette. 

Slide and hold OPEN/EJECT in the direction 

of the arrow, then pull the cassette holder cover 
open until it locks. The cassette holder opens 
automatically.

● Do not touch internal components.

Insert or remove a tape and press “PUSH” to 

close the cassette holder. 

● Be sure to press only the section labeled “PUSH” 

to close the cassette holder; touching other parts 
may cause your finger to get caught in the cassette 
holder, resulting in injury or product damage.

● Once the cassette holder is closed, it recedes 

automatically. Wait until it recedes completely 
before closing the cassette holder cover.

● When the battery pack’s charge is low, you may not 

be able to close the cassette holder cover. Do not 
apply force. Replace the battery pack with a fully 
charged one or use AC power before continuing.

Close the cassette holder cover firmly until it 

locks into place.

To protect valuable recordings
Slide the erase protection tab on the back of the 
tape in the direction of “SAVE”. This prevents the 
tape from being recorded over. To record on this 
tape, slide the tab back to “REC” before loading it.

● If you wait a few seconds and the cassette holder 

does not open, close the cassette holder cover 
and try again. If the cassette holder still does not 
open, turn the camcorder off then on again.

● If the tape does not load properly, open the 

cassette holder cover fully and remove the 
cassette. A few minutes later, insert it again.

● When the camcorder is suddenly moved from a 

cold place to a warm environment, wait a short 
time before opening the cassette holder cover. 

 

Make sure the camcorder’s power is off.

Open the card cover (

).

To load a memory card, firmly insert it with 

its clipped edge first.
To unload a memory card, push it once. After 
the memory card comes out of the camcorder, 
pull it out.

● Do not touch the terminal on the reverse side of 

the label.

Close the card cover.

To protect valuable files (available only for 
SD Memory Card)
Slide the write/erase protection tab on the side 
of the memory card in the direction of “LOCK”. 
This prevents the memory card from being 
recorded over. To record on this memory card, 
slide the tab back to the position opposite to 
“LOCK” before loading it.

● Some brands of memory cards are not compatible 

with this camcorder. Before purchasing a memory 
card, consult its manufacturer or dealer.

● Before using a new memory card, it is necessary 

to format the card. (

Do not insert or remove the memory card while the 
camcorder is turned on, as this may cause the 
memory card to be corrupted or cause the 
camcorder to become unable to recognize whether 
or not the card is installed.

GR-D370US.book  Page 18  Monday, August 28, 2006  4:42 PM