JVC GR-DF550 지침 매뉴얼
EN
55
EDITING
MasterPage: Start_Right
You can record a new scene into a previously
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in
and out points. The original audio remains
unchanged.
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in
and out points. The original audio remains
unchanged.
● Use the provided remote control.
NOTES:
● Before performing the following steps, make sure
● Insert Editing is not possible on a tape recorded in
the LP mode or on a blank portion of a tape.
1
Play back the tape, locate the Edit-Out point
and press PAUSE (9). Memorize the time code
at this point (
at this point (
墌 pg. 21) since it will be needed to
stop editing in step
5.
2
Press REW (
3
) until the Edit-In point is
located, then press PAUSE (9).
3
Press and hold INSERT (I) on the remote
control, then press PAUSE (9). The “9I”
indicator and the Time Code (min.:sec.) appear
and the camcorder enters Insert-Pause mode.
indicator and the Time Code (min.:sec.) appear
and the camcorder enters Insert-Pause mode.
4
Press START/STOP to begin editing.
● To pause editing, press START/STOP. Press it
again to resume editing.
5
When the time code reaches Edit-Out point
(time code from step
1), press START/STOP,
then STOP (8) to end Insert Editing.
NOTES:
● Program AE with special effects (墌 pg. 47) can
be used to spice up the scenes being edited
during Insert Editing.
during Insert Editing.
● During Insert Editing, the date and time
information changes.
● If you perform Insert Editing onto a blank space on
the tape, the audio and video may be disrupted.
Make sure you only edit recorded areas.
Make sure you only edit recorded areas.
● During Insert Editing, when the tape moves to
scenes recorded in the LP mode or a blank
portion, Insert Editing stops. (
portion, Insert Editing stops. (
Insert Editing
GR-DF550US_07Advanced.fm Page 55 Monday, February 28, 2005 6:44 PM