JVC GR-SX897 지침 매뉴얼
26
Playback Zoom
To magnify the recorded image up to 10X at any
time during playback. Make sure that the TBC
mode is activated.
time during playback. Make sure that the TBC
mode is activated.
1) Press PLAY
R
to find the scene of interest.
2) Press ZOOM (T/W)
E
. Pressing T zooms in. To
end zoom press and hold W until magnification
returns to normal. Or, press STOP
returns to normal. Or, press STOP
Y
and then
press PLAY
R
.
• Due to digital image processing, the quality of the
image may suffer.
Animation And Time-Lapse
The remote control lets you set/release interval
time and recording time without setting REC TIME/
INT. TIME (
time and recording time without setting REC TIME/
INT. TIME (
pg. 21) in SYSTEM MENU.
Animation
Each time ANIM.
Each time ANIM.
I
is pressed, the recording time
changes in the following order: 1/4S, 1/2S, 1S, 5S
and no indication (off).
and no indication (off).
Time-Lapse
Each time REC TIME
Each time REC TIME
I
is pressed, the recording
time changes in the following order: 1/4S, 1/2S,
1S, 5S and no indication (off). Each time INT. TIME
1S, 5S and no indication (off). Each time INT. TIME
d
is pressed, the interval time changes in the
following order: 15S, 30S, 1MIN, 5MIN and no
indication (off).
indication (off).
Insert Editing
You can record a new scene onto a previously
recorded tape. Only the video signal is recorded in
this mode.
1) Set the Power Switch
recorded tape. Only the video signal is recorded in
this mode.
1) Set the Power Switch
@
to “
” while pressing
down the Lock Button
!
located on the switch.
2) Play back the tape, locate the edit-out point and
press PAUSE
a
.
Press and hold COUNTER R/M
w
for more than 1 second to reset the tape
counter, then press it again for less than
1 second so that “M” appears.
1 second so that “M” appears.
3) Press REW
T
to go a little beyond the beginning
of the scene you want to replace, press PLAY
R
to view the recorded tape, and press PAUSE
a
exactly at the edit-in point where the new scene
should start.
should start.
4) While holding down INSERT
U
, press and
release PAUSE
a
.
w
appears.
5) To begin Insert Editing, press START/STOP
O
.
When the counter reaches “0:00:00”, editing
stops automatically and the camcorder enters
the Insert-Pause mode. To end Insert Editing,
press STOP
stops automatically and the camcorder enters
the Insert-Pause mode. To end Insert Editing,
press STOP
Y
.
• During Insert Editing, the original audio will be
heard from the speaker.
• After step 4), “Retake” (
pg. 13) can be
performed.
• The tape may stop slightly before or after the
designated end point, and noise bars may appear.
Neither indicates a defect in the unit.
Neither indicates a defect in the unit.
GR-SXM967-EN
3/11/03, 10:33 AM
26