JVC gr-sz7000 사용자 가이드

EN 

e

You can record a new soundtrack on a prerecorded tape
(in MONO on the normal audio track only.).
** Perform steps 1, 2 and 3 of the Insert Editing procedure

(

Z

 pg. 44) before continuing.

•The sound comes from the built-in mike (or an external

mike if connected).

FIND EDIT-IN POINT

Press REW to go a little beyond the beginning of the
scene onto which you want to dub new audio, press
PLAY to view the recorded tape, then press PAUSE
at exactly the point where dubbing should start.

ENGAGE AUDIO DUB STANDBY

MODE

Press and hold 

, and without releasing

A. DUB, press and release PAUSE.

BEGIN AUDIO DUBBING

Press PLAY. When the counter reaches “0:00:00”,
Audio Dubbing stops automatically and the
camcorder enters the Audio Dub-Standby mode.

END AUDIO DUBBING

Press STOP.

●

Do not press FF or REW during Audio Dub-Standby, or
the edit points will not be accurate.

●

If the mike is too close to the TV, or if the TV’s volume
is too high, whistling or howling may occur.

●

During Audio Dubbing, only the dubbed sound is
output. After Audio Dubbing is finished, press Hi-Fi/
MIX/NORMAL to select the required playback audio
soundtrack (

Z

 pg. 34).

• 

HiFi

: You can hear the original sound on the

prerecorded tape.

• 

Mix

: You can hear the dubbed sound and the

original one on the prerecorded tape.

• 

Normal: You can hear the dubbed sound.

●

Insert Editing and Audio Dubbing may not work
correctly if the tape contains blank segments, or if the
recording speed was changed during the original
recording.

●

To edit/dub onto a tape with the recording safety tab
removed, cover the hole with adhesive tape.

●

Do not press STOP during Insert Editing or Audio
Dubbing, or the edit points will not be accurate.

●

During Insert Editing and Audio Dubbing, when Insert–
Pause or Audio Dub–Standby is engaged, the counter
may go slightly past “0:00:00”. Recording, however,
stops at exactly 0:00:00.