JVC GY-DV500 사용자 가이드

37

 Connect the connectors protruding from the GY-DV500 with

the connectors on the battery holder.
* Following connection of the connectors, insert them into

the connector compartment and secure with the clamp.

 Secure the battery holder to the GY-DV500 with the four

mount screws provided with the battery holder.

 * Take care not to pinch the wires. This could result in

damage.

To use an Anton-Bauer battery pack (Propack 13/14, Trimpack 13/14, Magnum 13/14, Compack 13/14 Series), it is necessary to
detach the battery case from the GY-DV500 and replace it with the Anton-Bauer battery holder. Use the following battery holder.
• Battery holder: Anton-Bauer QRQ27

 Remove the two black screws 

A

 on the battery case.

 Remove the lower half of the battery case cover in the

downward direction.

 Align the 3 guide pins of the battery pack with

the guide holes on the battery holder, and push
straight to insert the battery pack.
The battery cannot be attached properly if the
guide pins are not inserted straight.

 Slide the battery pack toward the side panel

where the cassette cover is located until it clicks.
Now the battery pack has been attached.

n

While pushing and holding the release lever, slide
the battery pack toward the side panel where the
LCD display is located, then pull the battery pack
outward to remove.

 To remove the battery case, remove the four screws 

B

 fixing

the battery case and the connector connecting the battery
case to this unit.

Attaching the Anton-Bauer Battery Holder
Anton-Bauer Battery Holder

  Black screw 

A

 Mount screw 

B

LIGHT

ON

OFF

COUNTER

CTL

TC
UB

 Connector

 Mount screw 

B

Guide pins

Battery pack
(Trimpack)

Release lever

Cassette cover
side panel

Guide
holes
(x3)

Side panel
with display

Battery

Release
lever

Anton-Bauer
Battery holder

Connector
Compartment