GoVideo vr2940 제품 매뉴얼

다운로드
페이지 48
41
Disc Handling & Maintenance
Handling Precautions
•  Hold the disc by the edges so 
the surface will not be soiled 
with fingerprints.
•  Fingerprints, dirt and scratches 
can cause skipping and 
distortion.
•  Do not write on the label side 
with a ball-point pen or other 
writing utensil.
•  Do not use record cleaning 
sprays, benzine, thinner, static 
electricity prevention liquids, or 
any other solvent.
•  Be careful not to drop or bend 
the disc.
•  Do not insert more than one 
disc in the disc tray.
•  Do not try to close the disc tray 
when the disc is not installed 
properly. 
•  Be sure to store the disc in its 
original case when not in use.
If the surface is soiled
•  Wipe gently with a soft, damp (water only) cloth.
•  When wiping discs, always move the cloth from the 
center hole toward the outer edge. (If you wipe the 
disc using a circular motion, circular scratches are 
likely to occur, which will cause noise.)
If the disc is brought from a cold to a warm 
environment, moisture may form on the disc
•  Wipe moisture off with a soft, dry, lint-free cloth 
before using the disc.
Improper disc storage
You can damage discs if you store them in the 
following places:
•  Areas exposed to direct sunlight
•  Humid or dusty areas
•  Areas directly exposed to a heat outlet or heating 
appliance
Disc which cannot be played with this DVD 
Recorder+VCR
•  CD-ROM (Application Program)
•  CVD
•  Non-Region 1 encoded discs.
Maintenance
•  Be sure to turn the unit off and disconnect the AC 
power cord before maintenancing the unit.
•  Wipe this unit with a dry soft cloth. If the surfaces 
are extremely dirty, wipe clean with a cloth which 
has been dipped in a weak soap-and-water 
solution and wrung out thoroughly, and then wipe 
again with a dry cloth.
•  Never use alcohol, benzine, thinner, cleaning fluid 
or other chemicals. And do not use compressed air 
to remove dust.
7 - Help (cont.)
Power cord protection
To avoid any malfunctions of the unit, and to protect 
against electric shock, fire or personal injury, please 
observe the following:
•  Hold the plug firmly when connecting or 
disconnecting the AC power cord.
•  Keep the AC power cord away from heating 
appliances.
•  Never put any heavy object on the AC power cord.
•  Do not attempt to repair or reconstruct the AC 
power cord in any way.
Placement
Avoid placing the unit in areas of:
•  direct sunlight or heating radiators, or closed 
automobiles
•  high temperature (over 95°F) or high humidity 
(over 90%)
•  significant dust as the internal parts may be 
seriously damaged.
Non-use periods
When the unit is not being used, turn it off. When left 
unused for a long period of time, the unit should be 
unplugged from the household AC outlet.
No fingers or other objects inside
•  Touching internal parts of this unit is dangerous, 
and may cause serious damage to the unit. Do not 
attempt to disassemble the unit.
•  Do not put any foreign object in the disc tray.
Keep away from water
•  Keep the unit away from flower vases, tubs, sinks, 
etc. If liquids are spilled into the unit, serious 
damage could occur.
Keep away from magnets
Never bring a magnet or magnetized object near the 
unit.
Stacking
•  Place the unit in a horizontal position, and do not 
place anything heavy on it.
Condensation
Moisture may form on the lens in the following 
conditions:
•  immediately after a heater has been turned on
•  in a steamy or very humid room
•  when the unit is suddenly moved from a cold 
environment to a warm one
If moisture forms inside this unit, it may not operate 
properly. In this case, turn on the power and wait 
about one hour for the moisture to evaporate.
If there is noise interference on the TV while a 
broadcast is being received
Depending on the reception condition of the TV, 
interference may appear on the TV monitor while you 
watch a TV broadcast and the unit is left on. This is 
not a malfunction of the unit or the TV. To watch a TV 
broadcast, turn off the unit.