Hitachi 40gnx 설치 설명서
Handling precautions
Wear a grounded wrist strap while handling the
drive to prevent damage from Electrostatic
Discharge (ESD).
drive to prevent damage from Electrostatic
Discharge (ESD).
Set the drive down gently to prevent damage from
impact or vibration.
impact or vibration.
Do not open the ESD bag containing the drive until
needed.
needed.
Handle the drive carefully by the edges. Do not
touch the exposed printed circuit board or any
electronic components.
touch the exposed printed circuit board or any
electronic components.
Do not press on the top or bottom of the drive.
Do not cover the drive’s breather hole.
Quick installation
Installation of this Travelstar drive in some notebooks
may require use of unique hardware ( such as mounting
trays, connecting cable, insu lating material). If you are
uncertain if hardware is needed, consult your notebook
manufacturer as this operation may require a qualified
technician.
may require use of unique hardware ( such as mounting
trays, connecting cable, insu lating material). If you are
uncertain if hardware is needed, consult your notebook
manufacturer as this operation may require a qualified
technician.
Back up all data before proceeding with installation .
1.
Set the jumpers
Master drive. No jumper is required if the drive is
the only drive in a system or the Master drive in a
two-drive system.
the only drive in a system or the Master drive in a
two-drive system.
Slave drive. If this is the Slave drive in a system,
place a jumper in setting A2. (See the A2 setting in
the illustration.)
place a jumper in setting A2. (See the A2 setting in
the illustration.)
Cable Select. Setting A3 in the illustration. Consult
the system manual to see if your computer sup ports
Cable Select
the system manual to see if your computer sup ports
Cable Select
.
Jumper settings
A1.
A2.
A3.
A4.
A5.
Pin 1
A1. Master A2. Slave A3. Cable Select
A4 & A5. Never attach a jumper in these positions!
A4 & A5. Never attach a jumper in these positions!
2.
A
ttach the drive
For assistance on the physical instal lation of the drive,
consult your system manual.
consult your system manual.
3.
Configure the computer
1. Turn on the computer.
2. Enter Setup.
3. Go to Hard Disk Drive Configuration.
4. Select Autodetect if it is available.
5. If Autodetect is not available, set to User and set to
2. Enter Setup.
3. Go to Hard Disk Drive Configuration.
4. Select Autodetect if it is available.
5. If Autodetect is not available, set to User and set to
appropriate parameters from the table below.
6. Save the settings.
7. Exit.
8. Reboot the system from a floppy disk.
7. Exit.
8. Reboot the system from a floppy disk.
20
63
2
16,383
IC25N020ATCS05
40
63
4
16,383
IC25N040ATCS05
Capacity
(GB)
Sectors/
Track
Heads
Cylinders
Model Number
ibm
Quick installation guide
Travelstar 40GNX
2.5 inch ATA/IDE hard disk drive
IC25N020ATCS05
IC25N040ATCS05
Models:
IBM storage products
Page 1
IBM Technology Group Support Center
version 1.0