Hitachi 37hlx99 사용자 매뉴얼
Lamp
2
Lamp
1
11
First time use
햺 REMOTE CONTROL sensor
Point your remote at this area when selecting
channels, adjusting volume, etc.
channels, adjusting volume, etc.
햺 IR OUT sensor
Point your equipment’s remote control at this area.
The IR will pass through the IR Blaster cables
The IR will pass through the IR Blaster cables
햻 SIDE INPUT JACKS (for INPUT:5)
INPUT 5 provide Y-PBPR jacks for
connecting equipment with this capability, such as
a DVD player or Set Top Box. You may use
composite video signal for
connecting equipment with this capability, such as
a DVD player or Set Top Box. You may use
composite video signal for
this
input.
Front/Side Panel Controls
햹 POWER light indicator
To turn the TV ON, press the main power
switch located on the lower right side of the
TV. A red stand-by indicator lamp located on
the lower right of the front bezel will
illuminate. The LCD TV is now ready for
remote ON/OFF operation.
switch located on the lower right side of the
TV. A red stand-by indicator lamp located on
the lower right of the front bezel will
illuminate. The LCD TV is now ready for
remote ON/OFF operation.
Indicating Lamp
Power Status
Operating
When the main power switch is set to Off.
OFF.
When the main power switch on the TV
(Stand-by)
is ON.
Blinking
Blue
n
O
TV MAIN POWER is ON with no signal input
(Power Saving)
except antenna (no sync. signal).
Lamp 1
Lamp 2
Off
Off
Lights
Red
Off
OFF.
Lights
Blue
Off
Off
(Turning ON )
OFF.
TV MAIN POWER is ON ; but no picture is shown.
TV MAIN POWER is ON ; picture is shown.
Lights
Orange
Off
Off
NOTES:
1.
Your HITACHI LCD TV will appear to be turned OFF (lights orange) if there is no video input
when INPUT : 1, 2, 3, 4 and 5. Check the Power Light condition to make sure the TV is
turned off or in Stand-by mode (lights red) when not in use.
when INPUT : 1, 2, 3, 4 and 5. Check the Power Light condition to make sure the TV is
turned off or in Stand-by mode (lights red) when not in use.
2.
Remote Control can not turn ON/OFF the “MAIN POWER” of the TV.
Your component outputs may be labeled
Y, B-Y, and R-Y. In this case, connect the
components B-Y output to the TV’s P
components B-Y output to the TV’s P
B
input and the components R-Y output to
the TV’s P
the TV’s P
R
input.
Your component outputs may be labeled
Y-C
B
C
R
. In this case, connect the component
C
B
output to the TV’s P
B
input and the
component C
R
output to the TV’s P
R
input.
It may be necessary to adjust TINT to
obtain optimum picture quality when using
the Y-P
the Y-P
B
P
R
inputs (see page
43).
INPUT 3
, INPUT 4 and
INPUT 5 (Y/VIDEO) can
be used for composite video and component
video input.
video input.
NOTE: 1.
2.
3.
4.
햽
PHOTO INPUT
Insert USB cable from your Digital Camera, USB
memory or memory card USB drive to view your
digital still pictures (see
memory or memory card USB drive to view your
digital still pictures (see
page 27
).
to your equipment.
IR Sensor