Hitachi 37hlx99 사용자 매뉴얼

다운로드
페이지 96
52
On-Scr
een Display
Channel Manager
Channel Manager
Auto Channel Scan
Channel Manager
Move
SEL
Return
Channel List
Auto Channel Scan
Signal Meter
Channel Manager
    Move
SEL
  Select
Channel List
Auto Channel Scan
Signal Meter
Channel Manager
    Move
SEL
  Select
Signal Meter
Channel Manager
    Move
SEL
  Return
Channel
3
-
1
Strength
91
Peak
91
SNR
10
Channel List
Auto Channel Scan
Signal Meter
Channel Manager
    Move
SEL
  Select
Close
   Source
Air
OR
OR
OR
Start
Reset
Auto Channel Scan
Setup
Timers
Locks
TV Guide On Screen
Channel Manager
Audio
Video
    Move
SEL
  Select
Power Swivel
Select CHANNEL MANAGER to set your Antenna
options, run Auto Channel Scan, Check Signal Meter
and Set Channel List.
1.
Press CURSOR PAD
,  or CHANNEL WHEEL
buttons to highlight function.
2.
Press the SELECT button or CURSOR PAD 
 to
select.
Signal Meter
Select SIGNAL METER when using an indoor or outdoor
antenna. This feature will show the signal strength and
peak values of the Antenna signal to help you adjust your
antenna to optimize signal reception.
Use the CURSOR PADS and the SELECT button to
highlight and select CLOSE to exit.
NOTE: The Signal Meter will not be available (grayed
out) when watching analog channels.
Auto Channel Scan
This feature will automatically store active Analog and
Digital channels in Auto Channel Scan memory.
1.  Use the 
CURSOR buttons 
to highlight
AIR, CABLE (1) or CABLE(2) source.
2.
Press the CURSOR buttons
or
to highlight the
START or RESET option.
3.
Press the SELECT button to select.
or
NOTE: 1.
When a CableCARD is installed, Auto  
Channel Scan will not be available since 
channels will be fixed based on what was 
agreed upon by you and your cable 
operator.
2.
If certain channels are poor or not possible 
in cable(1) mode, set cable source to cable(2)
by using the CURSOR buttons 
 or .