Hitachi l26d204 사용자 가이드
16
DISPLAY
Press DISPLAY to display the current information on the screen.
When the TV receives a digital signal, the digital information will
When the TV receives a digital signal, the digital information will
appear.
62-1 HDTV Moving Picture1
CH-1
Digital Air
No Program Information is available
Sleep Timer
Off
English
Full
1080i
Channel number
•
Station name
•
Channel label (if preset)
•
Broadcast program name
•
V-Chip rating
•
Signal type
•
Sleep timer
•
Audio language
•
Program guide
•
Picture size
•
Resolution
•
When the TV receives an analog signal, the analog
When the TV receives an analog signal, the analog
information will appear.
14
Analog Cable
Sleep Timer
Off
Mono
Full
480i
Channel number
•
Channel label (if preset)
•
V-Chip rating
•
Signal type
•
Sleep timer
•
Picture size
•
Audio information
(Stereo, SAP or Mono)
•
Resolution
•
Press DISPLAY again to clear the call display.
NOTE:
After a few seconds, DISPLAY screen will return to normal TV-
operation automatically.
LAST CH
This button allows you to go back to the last channel selected by
pressing LAST CH. Press LAST CH again to return to the last
channel you were watching.
MUTE
Press MUTE to switch off the sound. The TV’s sound will be
silenced and “Mute” will appear on the screen. The sound can be
switched back on by pressing this button again or the VOL + or –.
SLEEP
To set the TV to turn off after a preset amount of time, press
SLEEP on the remote control. The clock will count up 10 minutes
for each press of the SLEEP button (Off, 0h 10m, 0h 20m, ..., 2h
0m). After the sleep timer is programmed, the display will appear
briefly every ten minutes to remind you that the sleep timer is op-
erating. To confirm the sleep timer setting, press SLEEP and the
remaining time will be displayed for a few seconds. To cancel the
sleep timer, press SLEEP repeatedly until the display turns to Off.
•
Quick guide for menu
operation
Example: Select Language.
1
Press INPUT to select TV mode.
2
Press SETUP/TV MENU. The TV menu screen will appear.
Audio
Channel
Locks
Setup
Main Menu
Video
>>
: Move
ENTER:Select
3
Press ▲ or ▼ to select “Setup”, then press ▶ or ENTER.
4
Press ▲ or ▼ to select “Menu Language”, then press ◀ / ▶ to
select the desired language.
…on the following pages the menu can be called in the same
…on the following pages the menu can be called in the same
way as here.
5
Press EXIT to return to the normal screen.
NOTE:
If no buttons are pressed for more than about 60 seconds, the
menu screen will return to normal operation automatically.
•
54H0321A_eng.indd 16
54H0321A_eng.indd 16
5/4/10 3:44:35 PM
5/4/10 3:44:35 PM