Delfield 7048-m 설치 설명서

다운로드
페이지 15
Display Cases 724, 7000, 9000 Series Service and Installation Manual
For customer service, call (800) 733-8829, (800) 773-8821, Fax (989) 773-3210, www.delfield.com
2
Display Cases 724, 7000, 9000 Series Service and Installation Manual
3
For customer service, call (800) 733-8829, (800) 773-8821, Fax (989) 773-3210, www.delfield.com
RECEIVING AND INSPECTING THE EQUIPMENT
Even though most equipment is shipped crated, care should be 
taken during unloading so the equipment is not damaged while 
being moved into the building.
Carefully check for any visible signs of damage to the cartons or 
containers. If evidence of damage exists, the package should be 
opened immediately and a joint inventory and examination of the 
contents should be made by you and the driver. Sign delivery 
receipt as damaged. Example— if (2) pieces of (5) are dam-
aged, you must indicate the number of units damaged.
Concealed damage
If a concealed loss or damage is discovered after you have 
given the carrier a clear delivery receipt, notify the carrier 
in writing immediately or within 10 days from the delivery 
date. If you phone the carrier, you must follow up the call 
in writing to protect your rights. You can only improve your 
position as a claimant by promptly reporting such loss or 
damage. You should also retain all cartons or containers, 
including packing material, until an inspection has been 
made or waived.
Filing a claim
Notation of loss or damage does not constitute the filing of 
a claim. You should file your claim in writing with the carrier 
immediately!
Carriers will furnish the necessary form upon request. You 
should also request an inspection. If a claim is filed by phone, 
always follow up immediately in writing.
Location
Delfield 7000 and 9000 Series and Model 724 display cases 
should be installed on a level surface away from any source 
of intense heat such as ovens or ranges. Do not install 9000 
Series units closer than 6" (15.2 cm) from the ceiling or 
counter. This will allow air flow to the machine compartment. 
The 724 should be installed on legs as provided (4" [10.2 cm] 
from the counter).
When using a Model 724 display case, never obstruct the 
flow of air to the top of the cabinet. Do not place or store any 
items on top surface of unit. Obstruction of air may cause 
damage to the compressor.
On 7000 Series pass-through or see-through units, the cabi-
net can be installed with the machine compartment side flush 
against a wall or obstruction as long as both the front and 
the rear louvers are unobstructed. Do not install 7000 Series 
mirrored units closer than 6" (15.2 cm) from the wall.
If installing a 7000 Series display case into a counter-top, you 
must seal the perimeter of the equipment with silicone seal-
ant (see diagram below).
INSTALLATION
For the most efficient refrigeration, be sure to provide good 
air circulation inside and out. Take care not to block air flow 
to the fans and allow space along the sides.
Do not pack the interior of the display case so full that air 
cannot circulate.
Leveling
A level cabinet looks better and will perform better because 
the doors will line up with the door frames properly, and the 
cabinet will not be subject to unnecessary strain.
Electrical connection
Refer to the amperage data on page 2 or the 
serial tag data and your local code or the 
National Electrical Code to be sure the unit 
is connected to the proper power source. A 
protected circuit of the correct voltage and 
amperage must be run for connection of the 
line cord or permanent connection to the 
unit.
The power should be disconnected when-
ever performing maintenance or repair 
functions. Failure to observe this warning 
may result in electrical shock and personal 
injury!