Clavia lead 3 사용자 가이드
NORD LEAD 3 V1.2x
10. MIDI implementation: System Exclusive implementation
Page 151
P
P
P
P
E
E
E
ER
R
R
RF
F
F
FO
O
O
OR
R
R
RM
M
M
MA
A
A
AN
N
N
NC
C
C
CE
E
E
E
D
D
D
D
U
U
U
UM
M
M
MP
P
P
P
This message contains the actual Performance. One complete message contains the data for one Perform-
ance. This message is transmitted from Nord Lead 3 in one of two cases:
ance. This message is transmitted from Nord Lead 3 in one of two cases:
• When a Performance Dump is initiated from the front panel.
• When a valid Performance Dump Request message has been received over MIDI.
The Message Type and Message Specification bytes in the SysEx message contains information about
from which location (Slot or memory location) the Performance Dump was sent. When a Performance
or Performance Bank is sent back to Nord Lead 3, it will end up in this location.
from which location (Slot or memory location) the Performance Dump was sent. When a Performance
or Performance Bank is sent back to Nord Lead 3, it will end up in this location.
• If the SysEx data for a complete Performance Bank is sent (using the “Bank Dump” command), infor-
mation about the location of each Performance within the Bank is sent.
When any or all of these Performances are sent back to Nord Lead 3, they will be stored in their
original memory locations when in Performance Bank Receive mode (see
When any or all of these Performances are sent back to Nord Lead 3, they will be stored in their
original memory locations when in Performance Bank Receive mode (see
).
• If the SysEx data for a single Performance is sent using the “Dump One” command, it is being sent
from the Slots and not from its original memory location.
This means that when the Performance is sent back to Nord Lead 3, it will not be stored, but placed
in the Slots. You will then have to manually save the Performance to a memory location.
This means that when the Performance is sent back to Nord Lead 3, it will not be stored, but placed
in the Slots. You will then have to manually save the Performance to a memory location.
• If the SysEx data for a single Performance is sent after receiving a Performance Dump Request mes-
sage, either a Performance in a specified memory location or in the Slots will be sent, depending on the
Message Type byte in the Performance Dump Request message. This will also determine where the
Performance will be placed when it is sent back to a Nord Lead 3.
Note! If the Performance is requested from the Slots, sending the Performance back will place it in
the Slots again. If the Performance is requested from a memory location, sending the Performance
back will place it to its original memory location when in Performance Bank Receive mode (see
Message Type byte in the Performance Dump Request message. This will also determine where the
Performance will be placed when it is sent back to a Nord Lead 3.
Note! If the Performance is requested from the Slots, sending the Performance back will place it in
the Slots again. If the Performance is requested from a memory location, sending the Performance
back will place it to its original memory location when in Performance Bank Receive mode (see
).