Clavia lead 2x 사용자 가이드
3. Basic operation: Using a control (expression) pedal
NORD LEAD 2X V1.0x
Page 20
3. If you want the connected pedal to duplicate the functionality of the M
ODULATION
W
HEEL
, press
the D
OWN
button until the D
ISPLAY
reads ‘E.oF’).
With this setting, the expression pedal will have the same function as the M
ODULATION
W
HEEL
.
4. If you instead want to select an independent control function for the pedal, press the S
TORE
button.
The D
ISPLAY
will flash, showing one of the abbreviations in the table below.
5. Use the U
P
/D
OWN
buttons to select one of the following control functions:
6. After you have made your choice, press S
TORE
again. You will return to the ‘E’ display.
7. Use the U
P
/D
OWN
buttons to select a control amount value (‘1’ to ‘7’). This value (shown to the
right in the D
ISPLAY
) determines the range of the pedal control signal. Lower values give a smaller
difference between the pedal’s “full up” and “full down” states. High values give a greater difference
between the pedal’s up and down states.
between the pedal’s up and down states.
8. If needed, repeat steps 5 to 10 to set pedal control function for the other slots.
9. Press S
HIFT
to exit the Special menu and return to play mode.
Nord Lead 2X will also recognize Expression pedal messages via MIDI as MIDI Controller #11.
Display shows:
Pedal assigned to:
LFO 1 Amount.
LFO 2 Amount.
Filter Cutoff Frequency.
FM Amount.
Oscillator 2 Pitch.