Canon B150 시작 가이드
58
❚ The fax beeps once to indicate that the document has been sent successfully.
TRANSMITTING OK
❚ If an error occurs during sending, the fax beeps intermittently for a few seconds. If
this happens, try sending the fax again.
❚ The fax automatically redials if the receiving fax does not answer or if the line is
busy. (You can specify the number of times it redials; see AUTO REDIAL in TX
SETTINGS, p. 85.)
SETTINGS, p. 85.)
❚ To stop sending before the fax is finished, press [STOP]. You may then need to lift
the operation panel to remove the document, see Clearing document jams, p. 62.
❚ If an error message appears on the LCD, correct the error and then press [STOP].
Refer to Error codes, messages and solutions, p. 110.
Automatic Dialling______________________________
■ Sending a document using One-touch Speed Dialling or
Coded Speed Dialling
After registering the One-touch numbers or Coded Speed Dialling numbers you can
send documents as follows:
send documents as follows:
1
Feed the document face-down into the Auto-
matic Document Feeder (ADF).
matic Document Feeder (ADF).
See Loading the document, p. 49.
You can set the resolution and the density, p. 51.
You can set the resolution and the density, p. 51.
2
Press the One-touch Speed dialling button
assigned to the number to which you wish to
fax.
assigned to the number to which you wish to
fax.
or
FINE
10
01
CANON USA
12345678999
CODED DIAL
CANON CANADA
9
0
2345678999
Press [CODED DIAL] and enter the appropriate
two-digit Coded Speed Dialling code.
two-digit Coded Speed Dialling code.
Wait a second for the number to appear after the
name of the number.
name of the number.
❚ If no number is registered for the button or code
you pressed, the LCD display shows the NO TEL#
message. Make sure you pressed the correct button
or entered the correct code and that the number
you want to dial is registered correctly.
message. Make sure you pressed the correct button
or entered the correct code and that the number
you want to dial is registered correctly.
❚ If you make a mistake, press [STOP]. Then press
the correct One-touch Speed Dialling button or
press [CODED DIAL] and re-enter the code.
press [CODED DIAL] and re-enter the code.
❚ If an error message appears on the LCD, correct
the error and press [STOP]. If necessary, refer to
Frequently Asked Questions, p. 104.
Frequently Asked Questions, p. 104.