Canon C755 사용자 설명서

Preface

Users in the U.S.A.

Pre-Installation Requirements for Canon Facsimile
Equipment

Supply a suitable table, cabinet, or desk. See the Appendix for the unit’s dimensions
and weight.

1. Only a single line, touch-tone or rotary telephone set is to be used.

2. Order an RJ11-C modular jack (USOC code), which should be installed by the

telephone company. If the RJ11-C jack is not present, installation cannot occur.

3. Order a normal business line from your telephone company’s business

representative. The line should be a regular voice grade line or the equivalent.
Use one line per unit.

DDD (DIRECT DISTANCE DIAL) LINE
-or-
IDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IF YOU
COMMUNICATE OVERSEAS

n

Canon recommends an individual line following industry standards, e.g. the 2500 (Touch
Tone) or 500 (Rotary/Pulse Dial) telephones. A dedicated extension off a PBX unit without
“Call Waiting” can be used with your MultiPASS C755 peripheral. Key telephone systems
are not recommended because they send non-standard signals to individual telephones for
ringing and special codes, which may cause a fax error.

This equipment should be connected to a standard 120-volt AC, three-wire grounded
outlet only. Do not connect this unit to an outlet or power line shared with other
appliances that cause “electrical noise.” Air conditioners, electric typewriters, copiers,
and machines of this sort generate electrical noise which often interferes with
communications equipment and the sending and receiving of documents.

Connection of the Equipment

This equipment complies with Part 68 of the FCC rules. On the rear panel of this
equipment is a label that contains, among other information, the FCC Registration
Number and Ringer Equivalence Number (REN) for this equipment. If requested, this
information must be given to the telephone company. This equipment may not be used
on coin service provided by the telephone company. Connection to party lines is
subject to state tariffs.