LXE vx7 사용자 가이드
Install Mounting Brackets
33
E-EQ-VX7OGWW-H
VX7 User’s Guide
Step 1b – Mount Vehicle RAM Clamp Mount
Note:
If you are using the RAM ball base, complete Step 1a and skip Step 1b.
1.
Determine the position for mounting
the RAM clamp mount. The clamp
mount can be used on a beam (such
as on a fork lift truck) up to 2.5”
(63.5 mm) wide and approximately
2” (50.8 mm) thick. The clamp may
be attached to a thicker beam by
substituting longer bolts (not
included). Be sure to position the
RAM clamp mount to allow access
to the switches and ports on the
bottom of the VX5.
the RAM clamp mount. The clamp
mount can be used on a beam (such
as on a fork lift truck) up to 2.5”
(63.5 mm) wide and approximately
2” (50.8 mm) thick. The clamp may
be attached to a thicker beam by
substituting longer bolts (not
included). Be sure to position the
RAM clamp mount to allow access
to the switches and ports on the
bottom of the VX5.
2.
Position the upper clamp piece with
ball (A) on the beam. Place the bolts
(B) through the holes in the upper
clamp piece.
ball (A) on the beam. Place the bolts
(B) through the holes in the upper
clamp piece.
3.
Position the lower clamp piece (C)
below the beam. Align the bolts with
the holes in the lower clamp piece.
below the beam. Align the bolts with
the holes in the lower clamp piece.
4.
Place the nylon locking nuts (D) on
the bolts and tighten the bolts.
the bolts and tighten the bolts.
Figure 22 RAM Clamp Mount
Components
Figure 23 Assembled RAM Clamp Mount