Canon n1000 네트워크 가이드
Setting the Printer IP Address
7
2-7
Note
ping -s <IP address> 479
Set the same address entered at Step 2.
Set the same address entered at Step 2.
Windows Sample:
ping 172.20.88.196 -l 479
z The -l entry is the alphabetic lower case “L” (not the number “1”).
z The subnet mask and gateway addresses are set to 0.0.0.0.
z The subnet mask and gateway addresses are set to 0.0.0.0.
This completes preparation for the protocol setting.
Setting the IP Address with the Printer Operation Panel
1
On the printer operation panel, press the Online button. The Online
lamp goes off.
lamp goes off.
2
Press the Setup button.
3
Press or to select the following items then press .
Set Interface Æ Ext. Network Æ Set TCP/IP Æ Frame Type
Set Interface Æ Ext. Network Æ Set TCP/IP Æ Frame Type
4
Press or to select “Ethernet II” then press .
5
Press or to select “IP Mode” then press .
6
Select the method for setting the printer IP address. Press or to
select either setting below then press .
Automatic:
Select when the IP address is to be set with DHCP, BOOTP, or RARP.
select either setting below then press .
Automatic:
Select when the IP address is to be set with DHCP, BOOTP, or RARP.
Manual:
Select when the IP address is to be assigned directly for the printer.
Select when the IP address is to be assigned directly for the printer.
00_J80xNG_Eng.book Page 7 Thursday, April 11, 2002 7:20 PM