Canon n1000 네트워크 가이드

Setting NetWare

®

 Frame Type

Important

Note

Before setting the printer protocol, you must follow the procedure below to 
enable communication between the computer that you are using and the 
printer.

z NetSpot must be installed on the computer that you are using. The system 

administrator should install NetSpot on the computer to be used. (Æ Setup Guide)

z If you are using an operating system that is not compatible with NetSpot, use 

another computer on the network to perform the setting.

z The following procedure is required for the MAC address. Follow the procedure 

below to confirm the MAC address and configure the printer:

1. Press the Online button. The Online lamp switches off.
2. Press the Cancel Job/Utility button.
3. Press  or  to select “Ext. I/F Print” then press .

z Before performing the procedure below, confirm that the printer is switched on and 

connected to the network.

1

Start NetSpot in the Administrator Mode.

2

If the Devices window is not open, from the Window menu, select 
New Window then select IPX Devices.

If the printer icon appears, the printer has recognized the printer and the 
procedure below is not required. Go to the next section. (Æ P.3-17)

z When the icon of the printer that you want to set appears in NetSpot, the printer 

and the computer that you are using are communicating normally, so the following 
procedure is not required. Go directly to performing the printer protocol settings. 
(Æ P.3-17)

00_J80xNG_Eng.book  Page 3  Thursday, April 11, 2002  7:20 PM