Canon n1000 설치 설명서
Setting Up the Printer
56
1-56
Note
Printhead Correction Settings
After the software has been installed, use the printer driver to perform the
original correction settings for the installed printhead. Perform this
procedure for all computers where the printer driver has been installed.
original correction settings for the installed printhead. Perform this
procedure for all computers where the printer driver has been installed.
The printhead correction settings are performed in the Printer Properties
window with the printer icon selected.
window with the printer icon selected.
The steps below describe the procedure for Windows 98.
If the computer is on, switch the computer off before you start this
procedure.
procedure.
1
Press the Power button to switch the printer on.
After a few seconds “Ready” is displayed in the operation panel and the
Online lamp lights.
Online lamp lights.
2
Switch the Windows computer on.
Set Media
Reset/Enter
Power
Online Message
Ink Replace
Online
Setup
Cancel Job/
Utility
00_J80xSG_Eng.book Page 56 Saturday, April 13, 2002 11:28 AM