Maytag mmv4205b 설치 설명서

Place the mounting plate against the wall and 
insert the toggle wings into the holes in the wall to 
mount the plate.

NOTE: Before tightening toggle bolts and wood 
screw, make sure to coincide bottom line of the 
Mounting plate with Horizontal line of “Rear wall 
Template” and then the Mounting plate is properly 
centered under the cabinet.

CAUTION: Be careful to avoid pinching fingers 
between the back of the mounting plate and the wall.

Tighten all bolts. Pull the plate away from the wall 
to help tighten the bolts.

You need to drill holes for the top support screws and 
a hole large enough for the power cord to fit through.

•

Read the instructions on the TOP CABINET 
TEMPLATE.

•

Tape it underneath the top cabinet.

•

Drill the holes, following the instructions on the 
TOP CABINET TEMPLATE.

CAUTION: Wear safety goggles when drilling holes in 
the cabinet bottom.

Remove and save screw that holds blower Plate 
to microwave.

Carefully pull out the blower unit. The wires will 
extend far enough to allow you to adjust the 
blower unit.

CAUTION: Do not touch blade of blower to prevent 
cracking and breaking. Hold outer case when the 
blower is removed and re-installed.

Remove “Parts “A” with Nipper or Scissors

Rotate blower unit counterclockwise 180°.

Wall

Bolt End

Toggle Wings

Toggle 
Bolt

Spacing for Toggles More 
Than Wall Thickness

Mounting 
Plate

Back of 
Microwave

Blower Motor 
Screw

Blower Motor

Blower motor 
screw.

Lift up the Blower Plate.

Before Rotation

Back of 
Microwave

Back of 
Microwave

After Rotation