Maytag mmv4205b 설치 설명서

다운로드
페이지 72
Installation Instructions
8
A.
REMOVING THE MICROWAVE 
OVEN FROM THE CARTON/
REMOVING THE MOUNTING 
PLATE
1.
Remove the installation instructions, Exhaust 
adaptor, filters, glass tray and the small hardware 
bag. Do not remove the Styrofoam protecting the 
front of the oven.
2.
Fold back all 4 carton flaps fully against carton 
sides. Then carefully roll the oven and carton over 
onto the top side. The oven should be resting in 
the Styrofoam.
3.
Pull the carton up and off the oven.
4.
Remove and properly discard plastic bags.
5.
Remove the 2 screws from the mounting plate. 
This plate will be used as the rear wall template 
and for mounting. 
NOTE: You will have to reuse two screws in original 
loction of outcase after removing mounting plate.
B.
FINDING THE WALL STUDS 
1.
Find the studs, using one of the following 
methods:
A. Stud finder–a magnetic device which locates 
nails.
OR
B. Use a hammer to tap lightly across the 
mounting surface to find a solid sound. This 
will indicate a stud location.
2.
After locating the stud(s), find the center by 
probing the wall with a small nail to find the edges 
of the stud. Then place a mark halfway between 
the edges. The center of any adjacent studs 
should be 16" or 24" from this mark.
3.
Draw a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED TO AT 
LEAST ONE WALL STUD.
Carton
Styrofoam
Screws
Screws
Mounting Plate
Wall Studs
Center
1.PLACEMENT OF THE MOUNTING PLATE