Canon lbp5970 사용자 가이드

38

This section describes how to connect the printer to a computer and 

network.

This printer is equipped with a LAN connector and USB connector.

By connecting the printer to a network such as Ethernet to be shared on the 

network, you can use the printer from a computer on the network. You can use 

UNIX, Windows, Mac OS, and other operating systems.

This printer includes a print server that supports 10BASE-T/100BASE-TX and 

is compatible with the TCP/IP, NetWare, AppleTalk (EtherTalk), and SMB 

protocols.

Connect the LAN connector on this printer and a hub port with a Category 5 

twisted pair cable. Have cables or a hub ready as needed. For compatible 

cables and hubs, contact your local authorized Canon dealer.

IMPORTANT

If more than one devices are connected to an AppleTalk network, turn on 

each device at an interval of ten seconds or longer.

NOTE

•

This printer recognizes the type of Ethernet (100BASE-TX or 10BASE-T) 

automatically.

•

If both 100BASE-TX devices and 10BASE-T devices are on the same 

network, a device such as a switching hub that supports both 100BASE-

TX and 10BASE-T is required. For more details, contact your local 

authorized Canon dealer.

•

If you connected this printer to a network, check the MAC address of the 

print server with Configuration Page Print, and then configure the network 

operating system (UNIX, etc.) and print server. For more details, see "

 

Network Guide".

Attach the ferrite core at approximately 10 cm from the end of the connector (A) 

connected to the printer.

NOTE

A ferrite core is supplied with the printer.

LAN Connector

Hub

Computer with 
100BASE-TX Connector

Computer with
10BASE-T Connector

Ethernet Cable

Approx. 10 cm

(A)