Canon lbp5970 사용자 가이드
59
Step
8
NOTE
After installing the paper feeder, you have to specify the settings for the
optional accessories in the [Device Settings] sheet in the printer driver. You
can obtain the status of the optional accessories automatically by clicking
[Get Device Status] in the [Device Settings] sheet.
If you cannot obtain the status of the optional accessories of the printer
automatically, select the installed optional accessories from [Paper Source
Options].
Installing RAM/ROM
Expansion RAM/ROM modules are to be installed on the main board at the
rear side of the printer. A Phillips screwdriver is required for installing a RAM/
ROM module. Have a screwdriver ready in advance that matches the size of
the screws. Observe the following guidelines when installing RAM or ROM.
rear side of the printer. A Phillips screwdriver is required for installing a RAM/
ROM module. Have a screwdriver ready in advance that matches the size of
the screws. Observe the following guidelines when installing RAM or ROM.
CAUTION
•
Be sure to turn the printer OFF, and then disconnect all the interface
cables and power cord from the printer before installing RAM/ROM. If
you attempt to install RAM/ROM when the printer is ON or any cable
is connected to the printer, this may result in an electrical shock.
•
Be careful when handling a RAM/ROM module. Touching the edges
or a sharp portion of a RAM/ROM module may result in personal
injury.
IMPORTANT
•
RAM/ROM modules contain components that are sensitive to static
electricity. Observe the following precautions when handling a RAM/ROM
module to prevent damage from static electricity.
- Touch a metal object to dissipate static electricity before handling a
RAM/ROM module.
- When handling a RAM/ROM module, do not touch anything that
generates static electricity such as the computer display.
- Do not touch the main board parts, printed wire, or connectors with your
hands.
- To prevent the RAM/ROM module from being affected by static
electricity, keep it in the protective bag until it is ready to be installed.
•
Be sure not to touch the switches on the main board. If you change the
switches, the printer does not operate properly.
1
Turn the printer and computer OFF a, remove the USB
cable b, and then disconnect the power plug from the AC
power outlet c.
2
Remove all the interface cables and the power cord from
the printer.
If there is not sufficient space to install the RAM/ROM module, move the printer to
a place where you can work easier.
3
Remove the rear cover.
Slide the opening (A) on the rear cover a little in the direction of the arrow
a
.
a
a
b
c
(A)
a