Ricoh 2035e 사용자 설명서
Solving Operation Problems
188
10
Important
r Do not turn off the main power
switch while the power indicator is
lit or blinking. If you do, the hard
disk and memory may be dam-
aged and failure could result.
lit or blinking. If you do, the hard
disk and memory may be dam-
aged and failure could result.
r Turn off the main power switch be-
fore pulling out the plug. If you
pull out the plug with the switch
on, the hard disk and memory may
be damaged and failure could re-
sult.
pull out the plug with the switch
on, the hard disk and memory may
be damaged and failure could re-
sult.
r Make sure that 100% is shown on
the display before you unplug the
machine. If a lower value is shown,
some data is currently present in
memory.
machine. If a lower value is shown,
some data is currently present in
memory.
r Right after a power failure, the in-
ternal battery needs to be suffi-
ciently recharged to guard against
future data loss. Keep the machine
plugged in and the main power
switch on for about one week after
the power loss.
ciently recharged to guard against
future data loss. Keep the machine
plugged in and the main power
switch on for about one week after
the power loss.
-RDS (Remote Diagnostic
System)
If your machine has a problem, a ser-
vice representative can perform vari-
ous settings over the telephone line
from the service station.
If you want to use this function,
change the User Parameter. See p.159
“User Parameters” (switch 25, bit 4).
vice representative can perform vari-
ous settings over the telephone line
from the service station.
If you want to use this function,
change the User Parameter. See p.159
“User Parameters” (switch 25, bit 4).