Ricoh 3224C 사용자 가이드
Remarks
146
7
Maintaining Your Machine
If the exposure glass or ADF is dirty,
copy clarity may be reduced. Clean
these parts if they are dirty.
copy clarity may be reduced. Clean
these parts if they are dirty.
❖
❖
❖
❖ Cleaning the machine
Wipe the ADF with a soft dry
cloth. If stains remain, wipe with a
well-wrung wet cloth, and then
wipe the water off with a dry cloth.
If the stains cannot be removed
with water, use a neutral deter-
gent.
cloth. If stains remain, wipe with a
well-wrung wet cloth, and then
wipe the water off with a dry cloth.
If the stains cannot be removed
with water, use a neutral deter-
gent.
Important
❒ Do not use chemical cleaners or or-
ganic solvents, such as thinner or
benzene. If such substances get in-
side the machine or melt plastic
parts, a failure might occur.
benzene. If such substances get in-
side the machine or melt plastic
parts, a failure might occur.
❒ Do not clean parts other than those
explicitly specified in this manual.
Other parts should be cleaned only
by your service representative.
Other parts should be cleaned only
by your service representative.
Cleaning the Exposure Glass
Clean 1 and 2.
Cleaning the ADF
Clean 1 and 2.
Cleaning the Guide Boards
R CAUTION:
AAAA
Turn off the main power switch.
BBBB
Open the Bypass Tray.
ZGGH420E
• The inside of the machine be-
comes very hot. Do not touch the
parts with a label indicating "
parts with a label indicating "
v"
(means hot surface). Touching
"
"
v" (means hot surface) could
result in a burn.
ZGJS827E
AFS032S
ThemisC1_EN_zentai_pre_FM.book Page 146 Thursday, June 30, 2005 8:21 PM