Ricoh 3224C 참조 가이드

Transmission Mode

❒ Polling TX Clear Report allows

you to verify Polling Transmission
has taken place. See p.13 “Polling
Transmission Clear Report”. If E-
mail TX Results is programmed in
a Quick Operation key, you can se-
lect whether a report e-mail is sent
after transmission. The destination
of this report can be selected from
the e-mail addresses in the destina-
tion list.

❒ You can program one of the Quick

Operation keys with operations for
this function. Using this key allows
you to omit steps

B and G. See

p.142 “General Settings/Adjust-
ment”.

❒ The communication fee is charged

to the receiver.

AAAA

Place the original, and then select
the scan settings you require.

Reference

p.13 “Placing Originals”, Fac-
simile Reference <Basic Features>
p.29 “Scan Settings”, Facsimile
Reference <Basic Features>

BBBB

Press [Transmission Mode].

CCCC

Press [Polling TX].

DDDD

Depending on the Polling Trans-
mission mode, use one of the fol-
lowing procedures:

Free Polling Transmission

A Check that [Free Polling TX] is se-

lected.

Default ID Transmission

A Select [Default ID TX].

ID Override Transmission

A Select [ID Override Transmission].
B Specify a 4-digit ID using the

number keys and [A], [B], [C],
[D], [E], and [F].

Note

❒ A Polling ID may be any four

numbers (0 to 9) and charac-
ters (A to F), except 0000 and
FFFF.

❒ If you make a mistake, press

[Clear]

or the

{{{{Clear/Stop}}}} key,

and then try again.

ThemisC1_Fax_EN-F_FM.book Page 12 Tuesday, January 11, 2005 4:59 PM