Haier HDE5000AW 사용자 가이드

clearance between the vent hood and the ground or

any other obstruction. The vent flap should be able to move freely, although

vertical orientation of the exhaust system is acceptable. Certain extenuating

circumstances could affect the performance of the dryer:

1. Only rigid or flexible metal duct work should be used.

2. Venting vertically through a roof may expose the exhaust system to down

drafts causing an increase in vent restriction.

3. Running the exhaust system through an uninsulatedarea may cause

condensation and faster accumulation of lint.

4. Compression of crimping of the exhaust system will cause an increase in

vent restriction.

The exhaust system should be inspected and cleaned a minimum of every 12

months with normal usage. The more the dryer is used the more often you

should check the exhaust system and vent hood for proper operation.
Side and Bottom Exhaust

For your convenience, your dryer can be exhausted through the side or the

bottom. If you need to change the exhaust on the dryer to the side or the

bottom of the cabinet, you will need to order the exhaust kit from your Haier

dealer or call 1- 800-313-8495

English

RECOMMENDED MAXIMUMM

Exhaust Hood Types

Recommended

Use only for short

run installations

No. of 90º

elbows

Rigid Metal

90 ft.

60 ft.

45 ft.

35 ft.

25 ft.

12 inches (30.5cm)

The total length of flexible metal duct shall not exceed 2.4 m.

5. In Canada, that only those foil-type flexible ducts, if any, specifically identified

for use with the appliance by the manufacturer shall be used. In the United

States, that only those foil-type flexible ducts, if any, specifically identified for

use with the appliance by the manufacturer and that comply with the UL Outline

for Clothes Dryer Transition Duct, Subject 2158A (2006), shall be used.

6. In Canada, that the exhaust duct shall be 102 mm in diameter. In the United

States, the required exhaust duct diameter.