Haier p42lv6-t1 사용자 가이드
Other functions
Display function
Press the DISPLAY button, then the channel number and
system will be displayed on the screen.
Press
system will be displayed on the screen.
Press
again,it is disappear.
the DISPLAY button
Press the I/II button will result in fast swap of NICAM function of current program.
NICAM
29
3
AUTO
B/G
B/G
Sleep
The TV set will switch automatically to standby at the preset time with the SLEEP
timer on. You may set the sleep time.
timer on. You may set the sleep time.
each press of SLEEP button repeatedly on the remote control to select the number of
preset minutes, the time will be set in sequence: (off, 10, 20, 30,60, 90, 120,150,180).
preset minutes, the time will be set in sequence: (off, 10, 20, 30,60, 90, 120,150,180).
To confirm the sleep time setting, press SLEEP and the remaining time will be displayed
for a few seconds.
for a few seconds.
To cancel the sleep time, press SLEEP repeatedly until the display turns to off.
Press the STILL button, the STILL will display on the screen,
at this time, the picture of TV is still, and press the STILL button
again, the picture will resume.
at this time, the picture of TV is still, and press the STILL button
again, the picture will resume.
STILL
Channel edit setup
0 ------
1 ------
2 ------
3 ------
4 ------
5 ------
6 ------
7 ------
1 ------
2 ------
3 ------
4 ------
5 ------
6 ------
7 ------
No
Channel Name
1 Press CH.EDIT button to open/close the Channel Name menu,
Note
Note
opens when automatically will select the current channel
number.
2 Press CH+/- button to select the desired channel number, and then
press OK button to confirm.
press OK button to confirm.
3 Press VOL+ button to move the cursor, and then use CH+/- button
to alter the letter.
to alter the letter.
4 When you are satisfied with your change, press the EXIT button to
return to normal viewing or press MENU button to return to the
previous menu.
return to normal viewing or press MENU button to return to the
previous menu.
Scan
This function fast glances over the channels(Skip as off) which each searches.
Press the SCAN button to start from the current channel, and switch a channel every 3
seconds, after scanning, and the program channel stop the current channel.
If you want to stop the function during auto tunning, simply press Scan or MENU button
again, at this time, the program will stop the program Finally glances over.
Press the SCAN button to start from the current channel, and switch a channel every 3
seconds, after scanning, and the program channel stop the current channel.
If you want to stop the function during auto tunning, simply press Scan or MENU button
again, at this time, the program will stop the program Finally glances over.