Frigidaire fes355esa 사용자 가이드

다운로드
페이지 28
27
Before you call
Solutions to Common Problems
OCCURRENCE
Oven smokes excessively during
broiling.
Self-cleaning cycle does not work.
Soil not completely removed after
self-cleaning cycle.
POSSIBLE CAUSE/SOLUTION.
Control(s) not set properly. Follow instructions under “Setting Oven Controls”.
Make sure oven is opened to Broil Stop Position.
Meat too close to the element. Reposition the rack to provide proper clearance
between the meat and the element. Preheat broil element. Preheat broil element
for searing.
Grid on broiler pan wrong side up and grease not draining. Always place grid on
the broiler pan with ribs up and slots down to allow grease to drip into pan.
Grease has built up on oven surfaces. Regular cleaning is necessary when
broiling frequently. Old grease or food spatters cause excessive smoking.
Control(s) not set properly. Follow instructions under “Oven Cleaning” in the
Electronic Oven Control Guide.
Self-cleaning cycle was interrupted. Follow steps under “Stopping or Interrupting
the Self-Cleaning Cycle” in the Electronic Oven Control Guide.
Failure to clean bottom, front top or oven, frame or door area outside oven seal.
These areas are not in the self-cleaning area, but get hot enough to burn on
residue. Clean these areas before the self-cleaning cycle is started. Burned-on
residue can be cleaned with a stiff nylon brush and water or nylon scrubber. Be
careful not to damage the oven seal.
Excessive spillovers in oven. Set self-clean cycle for a longer cleaning time.
Avoid Transportation Damage to your Range
If you have to move your range into/out of your residence or when moving to a new home, it is suggested that you take
the following precautions:
1. Screw in the levelling legs under the range.
2. Remove the racks and other utensils from the oven, and from the lower drawer.
3. Use adhesive tape to firmly secure the door and the drawer to the side panels.  Also attach the electric power cord in
the same manner.
4. Use a two-wheeled trolley with strap and fasten the range to it.  Cover the appliance with a heavy blanket to prevent
scratches and dents.
5. Avoid pulling or pushing the control panel when moving the appliance.