Frigidaire plru1777ds0 사용자 가이드

다운로드
페이지 13
4
This Use & Care Manual provides specific operating
instructions for your model. Use the refrigerator only as
instructed in this Use & Care Manual. Before starting the
refrigerator, follow these important first steps.
LOCATION
Choose a place that is near a grounded electrical outlet.
Do Not use an extension cord or an adapter plug.
If possible, place the refrigerator out of direct sunlight
and away from the range, dishwasher or other heat
sources.
The refrigerator must be installed on a floor that is level
and strong enough to support a fully loaded refrigerator.
INSTALLATION
                      Do Not install the refrigerator where
the temperature will drop below 40°F (4.5°C) or rise above
110°F (43°C). The compressor will not be able to maintain
proper temperatures inside the refrigerator.
                        Do Not block the toe grille on the
lower front of your refrigerator. Sufficient air
circulation is essential for the proper operation of
your refrigerator.
Installation Clearances
Allow the following clearances for ease of installation,
proper air circulation, and electrical connections:
Sides ----------------------- 3/8”
Back & Top ---------------- 1”
DOOR OPENING
NOTE: If your refrigerator is placed with the door hinge
side against a wall, you may have to allow additional
space so the door can be opened wider.
Installation
LEVELING
All four corners of your refrigerator must rest firmly on a
solid floor. Your refrigerator is equipped with adjustable
leveling feet.
NOTE:  It is Very Important for your refrigerator to be
level in order to function properly.  If the refrigerator is
not leveled during installation, the door may be
misaligned and not close or seal properly, causing
cooling, frost, or moisture problems.
To Level Your Refrigerator:
After discarding crating screws and wood base, use a
carpenter’s level to level the refrigerator from front-to-back.
Adjust the plastic leveling feet in front, ½ bubble higher, so
that the door closes easily when left halfway open.
DOOR REMOVAL
If door must be removed :
1. Gently lay refrigerator on its back, on a rug or blanket.
2. Remove two base screws and base panel.
3. Remove bottom hinge screws.
4. Remove plastic top hinge cover.
5. Remove screws from top hinge.
6. Remove top hinge from cabinet.
7. Remove door and bottom hinge from cabinet.
8. To replace door, reverse the above order and securely
tighten all screws to prevent hinge slippage.
Plastic
Leveling Feet 
Crating
Screw
Discard  The (4) Crating Screws
And (2) Wood Bases 
Turn
Left To
Raise
Turn
Right To
Lower
Unpacking and Leveling