Clover cdr-1610 사용자 설명서

4.1 General Information

▪ HDD is not included in the system as standard.
▪ Three of internal HDDs and one of removable HDD can be installed for the system.

PAL/NTSC

Selection Jumper

Figure 4-1: System Arrangement Plan

4.2 How to install

▪ Set the jumper setting to SLAVE position on the additional HDD.

NOTE: MAKE SURE THAT THE JUMPER SETTING IS CORRECT.

IF NOT, THE SYSTEM WILL NOT RECOGNIZE THE ADDITIONAL HDD.

▪ Turn off the power, and then remove the cover.
▪ Install the additional HDD in the space as shown in Figure 4-1.
▪ Connect the power connector & flat cable to the HDD.
▪ Reassemble the cover.
▪ Turn on the system and confirm that the system recognizes the additional HDD.

If the system fails to recognize the HDD, check for correct jumper settings and secure
cable connections.

NOTE: AFTER INSTALLING THE ADDITIONAL HDD, THE NEW HDD SHOULD

BE FORMATTED.

PLEASE REFER TO CHAPTER 3.4 “DISK MANAGER” FOR DETAILS.

- 64 -