Nortel 4134 사용자 가이드
Configuring a tunnel
183
[ip address <ipv4-address> <subnet-mask>] | [ipv6
<ipv6-address>]
—End—
Table 91
Variable definitions
Variable definitions
Variable
Value
<ipv4-address>
<subnet-mask>
<subnet-mask>
Specifies the IPv4 address and subnet mask.
<ipv6-address>
Specifies the IPv6 prefix address. You can also
enter the IPv6 prefix name.
enter the IPv6 prefix name.
Configuring tunnel source
Configure the IP address for the tunnel source. The tunnel source address
is the IP address of a local interface.
is the IP address of a local interface.
Procedure steps
Step
Action
1
To enter configuration mode, enter:
configure terminal
2
To specify the name of the tunnel to configure, enter:
interface tunnel <tunnel-name>
3
To configure tunnel source, enter:
[no] tunnel source <A.B.C.D>
—End—
Configuring tunnel destination
Configure the IP address for the tunnel destination. This is not required
for 6to4 tunnels.
for 6to4 tunnels.
The tunnel destination cannot be a point-to-point interface peer. It should be
reachable through a physical interface.
reachable through a physical interface.
Procedure steps
Step
Action
1
To enter configuration mode, enter:
Nortel Secure Router 4134
Security — Configuration and Management
NN47263-600
01.02
Standard
10.0
3 August 2007
Copyright © 2007, Nortel Networks
.