Nortel 2350 사용자 가이드
Configuring communication with RADIUS 571
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Deleting a server group
To remove a server group, type the following command:
clear server group group-name
For example, to delete the server group shorebirds, type the following command:
WSS
# clear server group shorebirds
success: change accepted.
The members of the group remain configured, although no server groups are shown:
WSS# show aaa
Default Values
authport=1812 acctport=1813 timeout=5 acct-timeout=5
retrans=3 deadtime=0 key=(null) author-pass=(null)
Default Values
authport=1812 acctport=1813 timeout=5 acct-timeout=5
retrans=3 deadtime=0 key=(null) author-pass=(null)
Radius Servers
Server Addr
Server Addr
Ports
T/o Tries Dead State
----------------- -----------------
-----------------------------------------------------
sandpiper
192.168.253.3 1812 1813 5 3 0 UP
heron
192.168.253.1 1812 1813
5 3 0 UP
coot 192.168.253.4 1812 1813
5 3 0
UP
egret 192.168.253.2 1812 1813
5 3 0 UP
Server groups
RADIUS and server group configuration scenario
The following example illustrates how to declare four RADIUS servers to a WSS and configure them into two
load-balancing server groups, swampbirds and shorebirds:
load-balancing server groups, swampbirds and shorebirds:
1
Configure RADIUS servers. Type the following commands:
WSS#
set radius server pelican address 192.168.253.11 key elm
WSS#
set radius server seagull address 192.168.243.12 key fir
WSS#
set radius server egret address 192.168.243.15 key pine
WSS#
set radius server sandpiper address 192.168.253.17 key oak
2
Place two of the RADIUS servers into a server group called swampbirds. Type the following command:
WSS#
set server group swampbirds members pelican seagull
3
Enable load balancing for swampbirds. Type the following command:
WSS#
set server group swampbirds load-balance enable
4
Place the other RADIUS servers in a server group called shorebirds. Type the following command:
WSS#
set server group shorebirds members egret pelican sandpiper