Optoma dv10 사용자 가이드

  *  

MAINTENANCE

E

NGLISH

Message

Power LED

(Blue)

Temp LED

(Orange)

Lamp LED

(Red)

Standby State

(Input power cord)

Flashing

Power On/Lamp lighting

Power Off/Cooling

Error (Thermal Failed)

Error (Fan Failed)

Flashing

Error (Lamp Failed)

■

  Move the projector closer to or farther from the screen.

■

  Press [Format] button on the remote control or [Projector menu] on 

the projector panel, go to “Display-->Format“. Try the different set-

tings.

■

  As possible, reposition the projector so that it is centered on the 

screen and below the bottom of the screen.

■

  Press [Keystone +/-] button until the sides are vertical on the re-

mote control.

■

  If possible, turn off the projector, then unplug the power cord and 

wait at least 20 seconds before reconnecting power.

■

  When the lamp reaches its end of life, it will burn out and may 

make a loud popping sound.  If this happens, the projector will not 

turn on until the lamp module has been replaced.  To replace the 

lamp, follow the procedures in the “Replacing the Lamp” section 

on page 50.