Aiwa HT-DV1 작동 가이드

7

A battery (CR2025) is already installed in the remote control
when shipped from the factory.
Remove the insulating tape from the battery holder by
pulling its end as shown below.

The maximum operating distance between the remote
control and the remote sensor of the system is
approximately 5 meters. If the operating range decreases,
replace the battery with a new one.

Insert a ballpoint pen or similar pointed tool in the notch of
the battery holder at the bottom, and then slide out the
battery holder. Place a new battery (CR2025) into the
battery holder with correct polarity.  Finally, push the holder
back into position.

• When operating with the remote control, point the top of

the remote control toward the DVD player.

• If the system is not going to be used for an extended

period of time, remove the battery to prevent possible
electrolyte leakage.

• The remote control may not operate correctly when:

- There is an intense light, such as sunlight, in the line

of sight between the remote control and the DVD player.

- There is fluorescent lighting near the remote sensor.
- Other remote controls are used nearby (those of a TV

set, etc.).

Replace the battery with Hitachi Maxell or Panasonic,
Part No. CR2025 only. Use of another battery may
present a risk of fire or explosion.
The battery may explode if mistreated. Do not
recharge, disassemble or dispose of in fire.

• Do not keep metallic objects such as rings, bracelets,

and keys near the battery. They may cause the battery
to short circuit.

• After removing the battery, be sure to keep it out of

reach of children.  If it is swallowed, consult a doctor
immediately.