Intermec 2430 사용자 가이드
Chapter 6—Configuration Command Reference
202
Trakker Antares 2400 Family System Manual
Menu System: Main Menu > Configuration Menu > Communications Menu > Serial
Port
Bar Codes: To disable LRC, scan one of these bar codes:
Disable LRC for COM1
Disable LRC for COM2
*$+YF1.0*
*$+YF2.0*
*$+YF1.0* *$+YF2.0*
Disable LRC for COM3
Disable LRC for COM3
Disable LRC for COM4
*$+YF3.0*
*$+YF4.0*
*$+YF3
.
0* *$+YF4
.
0*
Or: To enable LRC, scan one of these bar codes:
Enable LRC for COM1
Enable LRC for COM2
*$+YF1.1*
*$+YF2.1*
*$+YF1.1* *$+YF2.1*
Enable LRC for COM3
Enable LRC for COM3
Enable LRC for COM4
*$+YF3.1*
*$+YF4.1*
*$+YF3
.
1* *$+YF4
.
1*
Maximum Retries
Terminals: 2415, 2425, 2435, 2455, 2475, and 2485/6.
Description: Defines the number of times the terminal will attempt to send a
disconnect request message to the Intermec Gateway or DCS 30X. The
terminal sends connect and disconnect request messages to the Intermec
Gateway or DCS 30X when you turn the terminal on and off.
terminal sends connect and disconnect request messages to the Intermec
Gateway or DCS 30X when you turn the terminal on and off.
Tip: Intermec strongly recommends that you use the optimum setting of 7
retries.
retries.
Syntax: NRdata
Acceptable values for data are:
0
Terminal retries indefinitely
1-99 Number of retries
Default: 7
Menu System: Main Menu > Configuration Menu > Communications Menu > Advanced
Network
Bar Codes: To set the default number of maximum retries, scan this bar code:
Default Maximum Retries
*$+NR7*
*$+NR7*