Intermec nx 참조 가이드
RS-232—Output to host system
MB/NX/RM/00/E/970131
125
Connection—Dual RS-232 C
DTE
Ð
host
terminal
Ï
DCE
5V power supply
(jack)
3
2
host system
terminal
×
Ø
serial port
serial port
The default hardware configuration
of the MicroBar NX transmits data
on the DTE connector (to host) only.
of the MicroBar NX transmits data
on the DTE connector (to host) only.
1
4
5V power supply
(modular plug)
input device
•
undecoded pen
•
low-power wand emulation device (< 50 mA)
1. Switch off the host system.
2. Disconnect the terminal from the host system.
3. Use the dual RS-232 cable to connect the MicroBar NX between the
terminal and the host system.
4. Connect your data input devices to the MicroBar NX.
5. Connect the external power supply (jack or modular plug) to the
MicroBar NX.
6. Plug the power supply into the mains socket.
7. Switch on the host system.
M
Do not switch on the host system until you have connected up and plugged in
the external power supply.