Intermec nx 참조 가이드
RS-232—Output to host system
MB/NX/RM/00/E/970131
133
ACK positive acknowledge character
Scanning ACK activates the ACK/NAK protocol.
After a successful message transmission, the MicroBar NX waits until the end of the
protocol timeout before reading a new bar code (
protocol timeout before reading a new bar code (
Ð
Hardware/software protocols timeout
above in this section). If there is no positive acknowledge (ACK) before the end of the
specified timeout, the MicroBar NX emits 6 error beeps.
specified timeout, the MicroBar NX emits 6 error beeps.
Not Used (*)
ACK (HEX 06)
To use a different character for ACK:
1. Scan Compose Other ACK Character.
2. Scan the desired character code (
Ð
ASCII character codes
).
Compose Other ACK Character