Intermec SR60 참조 가이드
Chapter 5 — Configuring General Features
SR60 Scanner Programmer’s Reference Manual
141
• The Good Read Beep Frequency bar codes on page 142
adjust the pitch of the beeper to low, medium, or high.
• The Good Read Beep Duration bar codes on page 143 can be
adjusted to short (100 msec), medium (250 msec), or long
(500 msec).
(500 msec).
• The When to Beep bar codes on page 143 let you configure
the scanner to emit the good read beep when one of these
events completes:
events completes:
• Decode of a bar code label.
• Transmission of data from the scanner to the host.
• (RS-232 interface only) CTS activation at the host
terminal.
For more details about the beeper, see “About the Scanner LEDs
and Beeper” on page 7.
and Beeper” on page 7.
To set the beeper options
1
Scan the SET bar code.
2
Scan the bar code(s) for the options. you want to configure.
3
Scan the END bar code.
Note: For the loudest beep signal, set the beeper volume to 3
and the good read beep frequency to high.
and the good read beep frequency to high.
SET-------------------------------------
Beep Signal
Beep Off
---------