SATO CG412 사용자 가이드
Section 3: Operation and Configuration
Page 3-16
CG4 Series Operator Manual
3.8 DEFAULT SETTING MODE
When default setting mode is selected and executed in Operation Setting mode (refer to Section 3.5
Operation Setting Mode), the printer will reset to the default setting (factory preset) as listed below.
Operation Setting Mode), the printer will reset to the default setting (factory preset) as listed below.
*1. To be connected by Port1024 and Port1025 (2 port connections) or Port 9100 (1 port connection)
No.
Items to be reset
Default value
1
Offset (V, H)
Vertical = 0 dot, Horizontal = 0 dot
2
Pitch Offset
0 dot
3
Cut Offset
0 dot
4
Dispensing Offset
0 dot
5
Tear-Off Offset
0 dot
6
Label Size
Pitch 896 dot x Width 832 dot [203 dpi]
Pitch 1344 dot x Width 1248 dot [305 dpi]
Pitch 1344 dot x Width 1248 dot [305 dpi]
7
Print Speed
75 mm/sec (3 Inches/sec)
8
Print Darkness
3A
9
Sensor Type
Gap
10
Paper End Search
Roll
11
Zero Slash
Enabled
12
Proportional Pitch
Enabled
13
Initial Feed
Disabled
14
Auto Feed
Disabled
15
Operation mode
Continuous
- (No setting)
Tear Off
- (No setting)
Cutter
Mode 1 (Head position)
Dispenser
Mode 1 (Head position)
16
Interface
RS-232C
Baud rate=19200 bps, Protocol = Protocol for
driver
driver
LAN
Protocol for driver (ENQ response mode) *1
IEEE 1284
Protocol = Protocol for driver
USB
Protocol = Protocol for driver