SATO CG412 사용자 가이드
Section 4: Troubleshooting
CG4 Series Operator Manual
Page 4-3
4.1 ERROR SIGNAL TROUBLESHOOTING (Cont’d)
Contents
ON LINE
(POWER)
LED
ERROR
LED
Buzzer
Causes
Corrective Actions
Minor error
Cover open
Off
Blinking red
3 short
beeps
sound
sound
1) Cover is not closed
properly.
1) Close the cover.
Sensor error
1) Wrong sensor level.
2) Wrong sensor type.
3) Label meandering.
2) Wrong sensor type.
3) Label meandering.
1) Level adjustment.
2) Sensor type adjustment.
2) Sensor type adjustment.
Paper end
1) Out of paper.
1) Set the paper properly.
Ribbon end
1) Out of ribbon or ripped
ribbon.
2) Ribbon is not set
properly.
1) & 2) Set the ribbon
properly.
Option
Cutter error
Off
long blink
interval
3 short
beeps
sound
sound
1) Cutter is not connected.
2) Cut operation was not
2) Cut operation was not
performed successfully.
1) Connect the cutter unit.
2) Set and feed the paper
2) Set and feed the paper
again.
Warning
Buffer near
full
full
Blinking green
(Lights
alternately)
Blinking red
(Lights
alternately)
—
1) Free space for receive
buffer is low.
1) Pause the data transmis-
sion on the host side and
wait to have enough buf-
fer space.
wait to have enough buf-
fer space.
Ribbon near
end
end
—
1) Remaining amount of rib-
bon is little.
1) Ribbon replacement.