IBM 600e 사용자 가이드
sectors, cylinders, and so on) to use, and then initializes the card.
To initialize the card, do as follows:
To initialize the card, do as follows:
1
Type the following command:
ATAINIT drive_letter:
Note:
drive_letter
is the actual drive letter. For example, if
your ATA card has been assigned drive letter D, you
should type:
should type:
ATAINIT D:
2
Press Enter to accept the displayed information. If you want to
specify a drive parameter, type
specify a drive parameter, type
P
and press Enter. Then follow
the instructions in the window.
Using Memory Cards
For you to use memory cards on your system, your CONFIG.SYS file
must contain the following lines (in addition to the standard drivers
that are always required):
must contain the following lines (in addition to the standard drivers
that are always required):
DEVICEHIGH=C:\CARDSOFT\MTSRAM.EXE
DEVICEHIGH=C:\CARDSOFT\MTDDRV.EXE
Drive Letters
You need to know which drive letter to use to access the memory
card.
card.
Note:
Drive letters are shared by memory and Flash memory cards.
If you insert a memory card in slot 1, it will be assigned drive
E; if you insert a Flash memory card in slot 2, it will use drive
F.
If you insert a memory card in slot 1, it will be assigned drive
E; if you insert a Flash memory card in slot 2, it will use drive
F.
If you remove the memory card from slot 1, and insert a
second Flash memory card in slot 1, it will be assigned drive
E, because that is the drive letter assigned to slot 1 for
memory and Flash memory cards.
second Flash memory card in slot 1, it will be assigned drive
E, because that is the drive letter assigned to slot 1 for
memory and Flash memory cards.
Type the following and press Enter:
MTDDRV /?
Information similar to the following is displayed:
86
IBM ThinkPad 600E Online Book