Acer 6500 사용자 가이드
System Board
1-7
1.5.1
Installing a Pentium II Processor
Observe the ESD precautions when installing
or removing a system component.
or removing a system component.
Follow these steps to install a Pentium II processor:
1.
Place the retention mechanism over the CPU connector on the
system board. Secure it with the screws that came with the
package.
system board. Secure it with the screws that came with the
package.
Figure 1-2
Installing the Retention Mechanism
2.
Remove the Pentium II processor from its protective packaging.
Make sure that the latches on the sides of the module are not
pressed.
Make sure that the latches on the sides of the module are not
pressed.
3.
With the processor card golden fingers pointing downward, align
the processor to the posts of the retention mechanism.
the processor to the posts of the retention mechanism.
4.
Lower the processor into to the CPU connector on the system
board until the golden fingers touch the connector.
board until the golden fingers touch the connector.