Marvel 60rgd-ss-f 시작 가이드
USING YOUR REFRIGERATED DRAWERS
13
Figure 14
LED
Warning Alarms
The Sentry System
The Sentry System
™ monitor will let you know if your unit
is not functioning properly for the following reasons. Door
ajar, high or low temperature, and power failure. These
alarms are explained below.
ajar, high or low temperature, and power failure. These
alarms are explained below.
Door Ajar Alarm
If the drawer has been left open for over five (5) minutes,
the alarm will sound and the LED will flash green. This will
stop as soon as the drawer is closed, or can be reset by
pressing the “ON/OFF” button.
If the drawer has been left open for over five (5) minutes,
the alarm will sound and the LED will flash green. This will
stop as soon as the drawer is closed, or can be reset by
pressing the “ON/OFF” button.
High and Low Temperature
If your unit reaches temperatures outside normal operating
temperatures for your set point for more than one (1) hour,
an alarm will sound and the LED will flash red. This will
warn you that your contents have seen temperatures that
may not be conducive for long-term storage. This alarm
can be reset by pressing the “ON/OFF” button.
If your unit reaches temperatures outside normal operating
temperatures for your set point for more than one (1) hour,
an alarm will sound and the LED will flash red. This will
warn you that your contents have seen temperatures that
may not be conducive for long-term storage. This alarm
can be reset by pressing the “ON/OFF” button.
Power Failure
If your unit experiences a power failure, the LED will flash
amber until the alarm is reset by pressing the “ON/OFF”
button.
If your unit experiences a power failure, the LED will flash
amber until the alarm is reset by pressing the “ON/OFF”
button.
Reset Alarms
Press the “ON/OFF” button for approximately one (1) sec-
ond. This will reset all audible and display alarms when
the button is released.
Press the “ON/OFF” button for approximately one (1) sec-
ond. This will reset all audible and display alarms when
the button is released.
Enable/Disable Sentry System
™ Alarms
Press and hold the “SET” key for five (5) seconds to en-
able or disable the Sentry System™alarms. LED will display
a steady green when enabled or a steady amber when
disabled.
able or disable the Sentry System™alarms. LED will display
a steady green when enabled or a steady amber when
disabled.
Quick Reference Guide
The quick reference guide on page 14 and 15 can be
removed from this manual and retained near the appli-
ance for quick access to the Sentry System™ functions.
The quick reference guide on page 14 and 15 can be
removed from this manual and retained near the appli-
ance for quick access to the Sentry System™ functions.
37
Set