Revel gem 사용자 가이드
Figure 10. Wire gauge versus
maximum wire run (with a
maximum loop resistance of
0.07 ohms) for less than 0.2 dB
response error.
NOTE: “Loop resistance” is the
DC resistance measured at one
end of a loudspeaker cable, with
the other ends shorted together.
CONNECTIONS
REVEL ULTIMA GEM loudspeakers can be connected to an audio
system in three different ways: single-wired, bi-wired or bi-amplified.
Please read the following sections before proceeding with actual con-
nections. Also, be sure to observe the following points:
system in three different ways: single-wired, bi-wired or bi-amplified.
Please read the following sections before proceeding with actual con-
nections. Also, be sure to observe the following points:
• Use high-quality speaker cable with a maximum total loop resis-
tance (for each wire run) of 0.07 ohms or less. Use the chart in
Figure 10 below to determine the maximum wire gauge.
Figure 10 below to determine the maximum wire gauge.
A high loop resistance will result in mis-termination of the
filter networks, and serious degradation of sound quality.
Use high-quality connectors on the loudspeaker cables. Consult
your Revel dealer as to specific solutions for your application.
filter networks, and serious degradation of sound quality.
Use high-quality connectors on the loudspeaker cables. Consult
your Revel dealer as to specific solutions for your application.
• Turn off all audio system power before making any connections.
• Read the owner’s manuals that were included with your audio
components to confirm their connection procedures.
• Verify correct polarities (i.e.,
+ to + and − to −) when making
connections. Failure to do so will cause poor imaging and
diminished bass response.
diminished bass response.
• For bi-wired or bi-amplified applications, remove the shorting
straps (see Figures 12, 13, and 14 on the next three pages).
SINGLE-WIRED SYSTEM CONNECTIONS
For most applications, simply leave the shorting straps in place and
connect the
connect the
+ and − from a single amplifier channel to the HIGH
FREQUENCY INPUT terminals, as shown in Figure 11 (on the
next page).
next page).
REVEL ULTIMA GEM
Owner’s Manual
13
W
IRE
G
AUGE
(AWG) L
ENGTH
(
FEET
)
L
ENGTH
(
METERS
)
6
87
27
7
69
21
8
58
18
9
43
13
10
34
10
11
27
8
12
22
7
13
17
5
14
14
4
15
11
3
16
9
3
17
7
2
18
5
2
IMPORTANT