Panasonic dmc-fs15 사용자 가이드

VQT1W26

• This card has a format which is not recognized by the camera.

> Format the card again with the camera after saving necessary data on a PC etc. (P25)

• This message appears when the camera is not operating properly.

> Turn the camera off and on. If the message persists, contact the dealer or your nearest 

Service Center.

> Use a card compatible with this unit. (P16)

• You can only use an SDHC Memory Card if using cards with 4 GB or more capacity.

• An error has occurred accessing the card.

> Insert the card again.

> Insert a different card.

• It has failed to read or write data. 

> Remove the card after turning the power [OFF]. Insert the card again, turn the power on, 

and try to read or write the data again. 

• The card may be broken.

> Insert a different card.

• When you set the recording quality to [

] or [

], we recommend using a high-speed 

card with “10MB/s” or greater displayed on the package.

• In the event that it stops even after using a “10MB/s” card or higher, the data writing speed has 

deteriorated so it is recommended to make a backup and then format (P25).

• Depending on the type of SD Memory Card or SDHC Memory Card, motion picture recording 

may stop in the middle.

• A folder cannot be created because there are no remaining folder numbers that can be used. 

(P83)

> Format the card after saving necessary data on a PC etc. (P25) If you execute 

[NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100. 
(P24)

• The AV cable is connected to the camera.

> Press [MENU/SET] if you want to delete this message at once.

> Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect. (P24)

• This message also appears when the USB connection cable is connected to the camera only.

In this case, connect the other end of the USB connection cable to a PC or a printer. (P82, 84)

• The printer cannot print.

> Check the printer.

DMC-FS15PPC-VQT1W26_eng.book  95 ページ  ２００８年１２月８日　月曜日　午後７時１９分